Vera2 with zwave usbdongle

HOWTO use a Z-wave dongle with your Vera 2 hardware

Prerequisites

• Vera 2 hardware
• A compatible Z-wave USB dongle

Introduction

Here's a short manual on how to us a dongle with Vera 2. Vera 2 has an internal z-wave chip. However an external dongle can still be used.

The dongle is plugged into one of Vera's USB ports and contains a Z-Wave chip that communicates to your Z-Wave devices. Also, when you pair Vera to Z-Wave devices (that is, 'Add' Z-Wave devices), that pairing information is stored in the dongle. So, if you ever need to replace your dongle, you'll have to reset the Z-Wave devices and add them again or use the internal chip of your Vera to do this again.

Instructions

1. From the dashboard go to Z-Wave, Options and look for port. /dev/tts/1 (this is the address for the internal chip)

To switch to USB Z-Wave you will need to change that address to (0 being the bottom usb slot and 1 being the top).

/dev/usb/tts/0

or

/dev/usb/tts/1

2. Edit the address to whatever USB slot you are using, and don't forget the first forward slash!

References

please find more info in the forum here:

http://forum.mios.com/index.php?topic=4761 http://forum.mios.com/index.php?topic=7030