View source for Use ZME 06443 as Scene Controller with Vera

The ZME_06443 Wall Controller is a battery powered Z-Wave controller that can work as a standard Controller - controlling other devices with direct Z-Wave commands - and as scene trigger device for IP Gateways such as VERA. The following pictures show the user interface UI5, but the steps and actions are similar for UI4. 

<br> 

== <span class="mw-headline" id="Include_the_device"> Include the device </span>  ==

Turn VERA into inclusion mode then put the device into management mode by pushing all four buttons for 5 sec and then push the "Inclusion" button (button 3) of the ZME_06443 for 2 seconds. This will include the ZME_06443 as secondary controller into VERA. After a successful inclusion there will be a new device in the dashboard showing the scene controller. 

[[Image:Zme 06443.PNG]] 

<br> 

== <span class="mw-headline" id="Configure_the_device"> Configure the device </span>  ==

On default only single button works and the device is setup to control other devices directly. In order to work as a scene controller for a gateway two configuration values need to be set 

*Parameter: 13: single click behavior: turn to value 3 = scene control 
*Parameter: 14 double click behavior: turn to value 3 = scene control

[[Image:Zme 06443 param.PNG]] 

<br> 

The device has a wakeup capability to report the battery status. However this report should only happen once a week. Set the wakeup interval to 604800, that equals 1 week or to any other value you see as desirable. 

<br> 

[[Image:Zme 06443 config.PNG]] 

<br> 

Dont forget to hit the „configure node right now“ button on the very same dialog and to do a tripple click on the wall controller to wakeup the battery device and activate the configuration. 

<br> 

== <span class="mw-headline" id="Setup_the_scenes_and_the_triggers"> Setup the scenes and the triggers </span>  ==

Setup a new scene and assign certain action to the scene. Now pick the "trigger" tab and set a new trigger. Choose the Wal Controller just included and configured. Select the event type "A scene is activated" and pick a useful name for the event (eg. the action on the controller to be performed). 

[[Image:Zme 06443 trigger.PNG]] 

<br> 

Now you need to choose the scene number that is associated to certain actions on the controller. The following scenes are available. 

*Scene 1: Single Click on Upper Part of Paddle 
*Scene 2: Single Click on Lower Part of Paddle 
*Scene 3: Single Click Dim Up 
*Scene 4: Single Click Dim Down 
*Scene 5: Single Click Dim Up Stop 
*Scene 6: Single Click Dim Down Stop 
*Scene 11: Double Click on Upper Part of Paddle 
*Scene 12: Double Click on Lower Part of Paddle 
*Scene 13: Double Click Dim Up 
*Scene 14: Double Click Dim Down 
*Scene 15: Double Click Dim Up Stop 
*Scene 16: Double Click Dim Down Stop

Save the settings and you are done. For more information on the ZME Battery Wall Controller please refer to the [http://wiki.micasaverde.com/index.php/File:ZME_KFOB_in_en.zip Installation Manual].