GE ZW5301 45631

From MiOS
(Difference between revisions)
Jump to: navigation, search
(Created page with "The GE ZW5301 / 45631 is a wall-mountable Z-Wave scene controller. Be sure to remove the tabs behind the battery. In Vera, go into 'add device' mode. On the scene controller, ...")
 
Line 1: Line 1:
 
The GE ZW5301 / 45631 is a wall-mountable Z-Wave scene controller.  Be sure to remove the tabs behind the battery.
 
The GE ZW5301 / 45631 is a wall-mountable Z-Wave scene controller.  Be sure to remove the tabs behind the battery.
  
In Vera, go into 'add device' mode.  On the scene controller, hold the add and remove buttons until the orange led blinks twice, then immediately press the four 'scene off / down' buttons in order from top to bottom.
+
In Vera, go into 'add device' mode.  On the scene controller, hold the add and remove buttons until the orange led blinks twice, then immediately press the four 'scene off / down' buttons in order from top to bottom.  If the device doesn't add, try doing a factory reset on it by pressing and holding both the left side (OFF) of the #1 Group/Scene button (upper left) and the "Remove" button until the Green LED blinks twice (approx 3-6 seconds).

Revision as of 03:41, 25 April 2012

The GE ZW5301 / 45631 is a wall-mountable Z-Wave scene controller. Be sure to remove the tabs behind the battery.

In Vera, go into 'add device' mode. On the scene controller, hold the add and remove buttons until the orange led blinks twice, then immediately press the four 'scene off / down' buttons in order from top to bottom. If the device doesn't add, try doing a factory reset on it by pressing and holding both the left side (OFF) of the #1 Group/Scene button (upper left) and the "Remove" button until the Green LED blinks twice (approx 3-6 seconds).

Personal tools