Leviton Vizia Remote

To make Vera secondary to use the Leviton as primary you will need to follow these steps:

For UI5

1) First you will need to change the Z-Wave firmware to 2.78:

Setup -> Z-Wave Settings ->Options -> uncheck the option 'Use Z-Wave version 3.20 instead of 2.78' and Save.

2) After you check that the version is 2.78 and not 3.20, you will need to change the _UNIT_NAME_ unit to be secondary, to do this go to:

Setup -> Z-Wave Settings -> Advanced -> click Go next to 'Controller shift'

3) Bring the Leviton controller near the _UNIT_NAME_ unit, less than 5 feet and on the _UNIT_NAME_ unit go to:

Setup -> Z-Wave Settings -> Advanced -> click Go next to 'Copy Z-Wave network from a master controller'

4) Then, on the remote controller you must go to:

'Menu - System Setup - Advanced - Yes - Network - Primary utils - Send primary data'

 When the Vera unit is secondary, you will need to go to:

Setup -> Z-Wave Settings -> Options -> uncheck the options 'By default Vera should automatically configure devices' and 'Use Vera routing instead of Z-Wave (requires 4.5)'.

For UI4

1) First you will need to change the Z-Wave firmware to 2.78:

Z-Wave device -> Options -> uncheck the option 'Use Z-Wave version 3.20 instead of 2.78' and Save

 2) After you check that the version is 2.78 and not 3.20, you will need to change the _UNIT_NAME_ unit to be secondary, to do this go to:

Z-Wave device -> Advanced -> click Go next to 'Controller shift'

3) Bring the Leviton controller near the _UNIT_NAME_ unit, less than 5 feet and on the _UNIT_NAME_ unit go to:

Z-Wave device -> Advanced -> click Go next to 'Copy Z-Wave network from a master controller'

4) Then, on the remote controller you must go to:

'Menu - System Setup - Advanced - Yes - Network - Primary utils - Send primary data'

When the Vera unit is secondary, you will need to go to:

Z-Wave device -> Options -> uncheck the options 'By default Vera should automatically configure devices' and 'Use Vera routing instead of Z-Wave (requires 4.5)'.