Supported Hardware
This will have a list of supported hardware. For now, refer to the MiCasaVerde Shop
Contents |
Hardware Reported to Work
- We strongly encourage users to list any and all products they tested and installed.
- If a product works but you did not like it, please list it anyway. It may be the only product available to some users.
IMPORTANT! The devices listed here have been added by installers,technicians and users like yourself. Results may vary upon installations. MiCasaVerde does not guarantee operation and compatibility with your installation. The listed devices were found to work with their specific installation. Mixing different series and brands of equipment is not guaranteed in any way to work with other series and brands. It is very likely that users have not fully tested all features of the devices, so it is possible that a device listed here as compatible, will not prove compatible with your hardware. If you are editing this wiki DO NOT REMOVE a listed working device if it hasn't worked for you. Seek help to get the device to work under your individual circumstance. If you are adding to this wiki, please provide links to data for the device and add any tips you feel may benefit someone wanting to implement the device into an installation
Lighting Devices
| Manufacturer | Device Type | Model no. | Version | Date Purchased | Location (indoor/outdoor) | Specs | Product Review | Added by User | Notes |
|---|---|---|---|---|---|---|---|---|---|
| Leviton | Dimmer Switch | VRM10-1LX | 1 | Nov 2008 | Indoor | Link | Link | mark-hc | This is a high quality dimmer geared towards high-end installations |
| Intermatic | 3-way Dimmer Switch | HA20 | Nov 2008 | Indoor | Link | Link | Affordable 3-way 600W dimmer | ||
| ACT | 2-way Dimmer Switch | ZDW120 | Nov 2008 | Indoor | Link | Link | WSeverino | Works well, easy to install, LED is a very bright blue....can be programmed to be off when the light is off or on. | |
| ACT | 3-way Dimmer Switch | ZDW103 | Nov 2008 | Indoor | Link | Link | WSeverino | Works well, can be tricky to install due to the different combination of 3 way circuits, LED is a very bright blue....can be programmed to be off when the light is off or on. |
Plug & Receptacle Devices
| Manufacturer | Device Type | Model no. | Version | Date Purchased | Location (indoor/outdoor) | Specs | Product Review | Notes | |
|---|---|---|---|---|---|---|---|---|---|
| Intermatic | In-Wall Receptacle | CA3500 | 1 | Nov 2008 | Indoor | Link | Link | This is a decent, but expensive solution for in-wall receptacles | |
| Intermatic | Appliance Module | HA02 | 1 | Nov 2008 | Indoor | Link | Link | Seems to work well | |
| ACT | In-Wall Receptacle | ZRR150W | 2.2 | Nov 2008 | Indoor | Link | Link | Works like a champ! Easy to Install |
Thermostat Devices
| Manufacturer | Device Type | Model no. | Version | Date Purchased | Location (indoor/outdoor) | Specs | Product Review | Notes |
|---|---|---|---|---|---|---|---|---|
| Wayne Dalton | Wall Stat | WDTC-20 | ?? | Nov 2008 | Indoor !! Link | Link | Shows up as Standard Thermostat, shows room temp, as well as controlling HVAC
|
Sensors
| Manufacturer | Device Type | Model no. | Version | Date Purchased | Location (indoor/outdoor) | Specs | Product Review | Notes |
|---|---|---|---|---|---|---|---|---|
| ACT | Motion Sensor | PIR000 / PIR010 | Indoor | Remove the cover, pair to Vera's dongle by using the push-button on the left of the circuit board. Vera must configure it to work, and it can only be configured within a few minutes of inserting the batteries. With Vera's dongle removed, remove/reinsert the batteries, and within 30 seconds insert Vera's dongle. Within a few minutes confirm the "configure" icon for the device is green on Vera's setup page | ||||
| Express Controls | 3-in-1 sensor | Pair using the blue button. The sensor will accept configuration within a few minutes of pressing the blue button, whether or not you are actually pairing or just pushing the button. So, with Vera's dongle removed, pair it or press the blue button if it's already paired, and within 30 seconds insert Vera's dongle. Within a few minutes confirm the "configure" icon for the device is green on Vera's setup page. This will show up as a device with 3 embedded devices (motion sensor, light sensor, thermometer) | ||||||
| EverSpring/Hawking/Home Managemeables | Door/window sensor | Pair using the intrusion button. The sensor will accept configuration within a few minutes of the initial pairing, or of pressing the intrusion button on the back even after it's paired. Pair the device, or if it's already paired, press the intrusion button, and within 30 seconds insert Vera's dongle. Within a few minutes confirm the "configure" icon for the device is green on Vera's setup page |
Controller/Gateway
| Manufacturer | Device Type | Model no. | Version | Date Purchased | Location (indoor/outdoor) | Specs | Product Review | Notes |
|---|---|---|---|---|---|---|---|---|
| Wayne Dalton | Gateway | WDHA-12R | ?? | Nov 2008 | Indoor | Link | Link | Shows as Z-Wave controller, a pain to sync with Homelink car remote, able to associate with devices, but not through Vera yet. Can now turn on/off All Z-wave devices from car. This gateway is required for the 3-button remote sold by them. Translates commands to Z-Wave Scenes.
|
