Raspberry Pi - Interfacing with Vera

Interfaces

Other

Mail sensor

http://learn.adafruit.com/raspberry-pi-e-mail-notifier-using-leds/overview

Temperature and humidity sensor

http://learn.adafruit.com/adafruits-raspberry-pi-lesson-11-ds18b20-temperature-sensing/

http://learn.adafruit.com/dht-humidity-sensing-on-raspberry-pi-with-gdocs-logging/overview

Motion sensor

HW used: https://www.sparkfun.com/products/8630

WARNINGS:

The colors of the wires can vary greatly. Looking at the unit from the top, the middle wire is ground, the left-most wire is the alarm, and the right-most is the power.

You have to solder a new wire to the L78L05 (http://www.fairchildsemi.com/ds/LM/LM78L05A.pdf; SOT-89) voltage regulator’s output or remove the regulator entirely and bridge the input pad to the output pad if you are driving the sensor with 5V.

The GPIO pins are NOT 5V tolerant and are NOT over-voltage protected. You have to reduce the PIR alarm voltage to 3.3V.

http://learn.adafruit.com/adafruits-raspberry-pi-lesson-12-sensing-movement

Door sensor

http://learn.adafruit.com/adafruits-raspberry-pi-lesson-12-sensing-movement

LED

http://learn.adafruit.com/raspberry-pi-e-mail-notifier-using-leds/wire-leds