ITemp
From MiOS
(Difference between revisions)
| Line 2: | Line 2: | ||
*Make sure you have at least version 1.5.622 on your unit | *Make sure you have at least version 1.5.622 on your unit | ||
| − | *Go to Apps -> Install Apps | + | *Go to Apps -> Install Apps |
| − | *Login if needed | + | *Login if needed |
| − | *Search for "iTemp" and install it | + | *Search for "iTemp" and install it |
*After the plugin is installed a new generic device will be installed | *After the plugin is installed a new generic device will be installed | ||
| + | |||
| + | [[Image:Generic-plugin.png]] | ||
| + | |||
*Go to the Advanced tab and locate the '''iTemp_Devices''' variable | *Go to the Advanced tab and locate the '''iTemp_Devices''' variable | ||
| + | |||
| + | [[Image:Itemp variable.png]] | ||
| + | |||
*Fill in the Device #ID of the physical iTemp device, which you already included in the network | *Fill in the Device #ID of the physical iTemp device, which you already included in the network | ||
Revision as of 12:22, 30 April 2013
iTEMP is a complex device with Temperature sensor, binary sensor and even thermostat functions. To fully support ZME iTEMP in VERA the following steps are required:
- Make sure you have at least version 1.5.622 on your unit
- Go to Apps -> Install Apps
- Login if needed
- Search for "iTemp" and install it
- After the plugin is installed a new generic device will be installed
- Go to the Advanced tab and locate the iTemp_Devices variable
- Fill in the Device #ID of the physical iTemp device, which you already included in the network
