ITemp
From MiOS
(Difference between revisions)
(Created page with "To fill") |
|||
| Line 1: | Line 1: | ||
| − | To fill | + | iTEMP is a complex device with Temperature sensor, binary sensor and even thermostat functions. To fully support ZME iTEMP in VERA the following steps are required: |
| + | |||
| + | *Make sure you have at least version 1.5.622 on your unit | ||
| + | *Upload the two plugin files into VERA: Go to Apps -> Develop Apps -> Luup Files, click browse and choose each of these files. | ||
| + | *After the files were uploaded you have to create a virtual device in Apps -> Develop Apps -> Create Device, type in a Description as the name and as Device file use D_iTemp.xml and as Implementation file I_iTemp.xml. Afterwards click on "Create device" | ||
| + | *On the Dashboard you will have a new device with the name you've given and in the Advanced tab of the device, you should have a variable called "iTemp_Devices". You can fill the variable with the device id (Settings tab) of the iTemp device you already included into the network. | ||
| + | *After you save the changes you should get another binary sensor on the Dashboard which should be tripped/untripped according to the tripped state of the master device. | ||
Revision as of 07:30, 30 April 2013
iTEMP is a complex device with Temperature sensor, binary sensor and even thermostat functions. To fully support ZME iTEMP in VERA the following steps are required:
- Make sure you have at least version 1.5.622 on your unit
- Upload the two plugin files into VERA: Go to Apps -> Develop Apps -> Luup Files, click browse and choose each of these files.
- After the files were uploaded you have to create a virtual device in Apps -> Develop Apps -> Create Device, type in a Description as the name and as Device file use D_iTemp.xml and as Implementation file I_iTemp.xml. Afterwards click on "Create device"
- On the Dashboard you will have a new device with the name you've given and in the Advanced tab of the device, you should have a variable called "iTemp_Devices". You can fill the variable with the device id (Settings tab) of the iTemp device you already included into the network.
- After you save the changes you should get another binary sensor on the Dashboard which should be tripped/untripped according to the tripped state of the master device.
