GE ZW5301 45631
From MiOS
(Difference between revisions)
Micasaverde (Talk | contribs) (Created page with "The GE ZW5301 / 45631 is a wall-mountable Z-Wave scene controller. Be sure to remove the tabs behind the battery. In Vera, go into 'add device' mode. On the scene controller, ...") |
|||
| (One intermediate revision by one user not shown) | |||
| Line 1: | Line 1: | ||
| + | [[Category:Hardware]] | ||
The GE ZW5301 / 45631 is a wall-mountable Z-Wave scene controller. Be sure to remove the tabs behind the battery. | The GE ZW5301 / 45631 is a wall-mountable Z-Wave scene controller. Be sure to remove the tabs behind the battery. | ||
| − | In Vera, go into 'add device' mode. On the scene controller, hold the add and remove buttons until the orange led blinks twice, then immediately press the four 'scene off / down' buttons in order from top to bottom. | + | In Vera, go into 'add device' mode. On the scene controller, hold the add and remove buttons until the orange led blinks twice, then immediately press the four 'scene off / down' buttons in order from top to bottom. If the device doesn't add, try doing a factory reset on it by pressing and holding both the left side (OFF) of the #1 Group/Scene button (upper left) and the "Remove" button until the Green LED blinks twice (approx 3-6 seconds). |
Latest revision as of 03:07, 15 June 2013
The GE ZW5301 / 45631 is a wall-mountable Z-Wave scene controller. Be sure to remove the tabs behind the battery.
In Vera, go into 'add device' mode. On the scene controller, hold the add and remove buttons until the orange led blinks twice, then immediately press the four 'scene off / down' buttons in order from top to bottom. If the device doesn't add, try doing a factory reset on it by pressing and holding both the left side (OFF) of the #1 Group/Scene button (upper left) and the "Remove" button until the Green LED blinks twice (approx 3-6 seconds).
